HIKVISION AX DS-PWA32-HSR

Note
The keypad password +1 or -1 is the duress code. Use the duress code can operate the keyboard
to arm and disarm normally and upload a duress alarm. For example, if the keypad password is
123456, the duress code is 123455 or 123457
6. Check
parons
7. Check the check boxes to set the user permission.
The user can only operate the assigned permissions.
8.
Click OK.
9.
Oponal: Enable the user in the Enable User column to allow the enabled user operang the
device.
10.
Oponal: Select an user and click Edit and you can edit the user's informaon and permission.
11.
Oponal: Delete a single user or check mulple users and click Delete to delete users in batch.
Note
The admin, the installer and the manufacture cannot be deleted.
Add/Edit/Delete Keyfob
You can add keyfob to the security control panel and you can control the security control panel via
the keyfob. You can also edit the keyfob informaon or delete the keyfob from the security control
panel.
Steps
1. Click User Management → Keyfob to enter the Keyfob Management page.
AX Security Control Panel
48