User Manual of Network Fisheye Camera
37
Figure 5-13 SNMP Settings
2. Check the corresponding version checkbox ( ,
, ) to enable the feature.
3. Configure the SNMP settings.
Note: The settings of the SNMP software should be the same as the settings you
configure here.
4. Click Save to save and finish the settings.
Note: A reboot is required for the settings to take effect.
5.3.6 Configuring 802.1X Settings
Purpose:
The IEEE 802.1X standard is supported by the network cameras, and when the feature
is enabled, the camera data is secured and user authentication is needed when
To Next Page
Loading...
