User Manual of Network Fisheye Camera
93
parameters of the camera.
Transparent Channel: Connect a serial device directly to the camera. The serial
device will be controlled remotely by the computer through the network.
Steps:
1. Enter RS-232 Port Setting interface:
Configuration> Advanced Configuration> System > RS232
Figure 9-16 RS-232 Settings
Note: If you want to connect the camera by the RS-232 port, the parameters of the
RS-232 should be exactly the same with the parameters you configured here.
2. Click Save to save the settings.
9.9 DST Settings
Purpose:
For region using the summer time, DST (daylight saving time) settings can be
configured according to the actual needs.
Steps:
1. Enter DST Settings interface:
Configuration> Advanced Configuration> System > DST
2. Check the checkbox of Enable DST to enable daylight saving time.
3. Set the start time and end time for the DST period.
4. Select the DST bias from the drop-down list.
5. Click Save to save the settings.
To Next Page
Loading...
Need help?
General
