User Manual of All-in-One Network Video Recorder
66
Figure 6. 5 Edit Schedule
III. To arrange other schedule, leave the All Day checkbox blank and set the Start/End time.
Up to 8 periods can be configured for each day. And the time periods cannot be overlapped each other.
IV. Select the record type in the dropdown list.
To enable Motion, Alarm, M | A (motion or alarm), M & A (motion and alarm) and VCA (Video
Content Analysis) triggered recording and capture, you must configure the motion detection
settings, alarm input settings or VCA settings as well. For detailed information, refer to Chapter
8.1, Chapter 8.2 and Chapter 8.5.
The VCA settings are only available to the smart IP cameras.
V. Repeat the above edit schedule steps to schedule recording for other days in the week. You can
click Copy to enter the Copy to interface to copy the schedule settings to other days
VI. Click Apply in the Record Schedule interface to save the settings.
Draw the schedule:
I. Click on the color icons, you can choose the schedule type as continuous or event.
Figure 6. 6 Draw the Schedule
Descriptions of the color icons are shown in the figure below.
Figure 6. 7 Descriptions of the color icons
To Next Page
Loading...
Need help?
General
