Network Video Recorder User Manual
57
Step 3 Set the password of the camera to activate it.
Use Admin Password: when you check the checkbox, the camera (s) will be configured with
the same admin password of the operating NVR.
Figure 2-27 Set New Password
Create New Password: If the admin password is not used, you must create the new password
for the camera and confirm it.
Strong Password recommended–We highly recommend you create a strong password of your own
choosing (Using a minimum of 8 characters, including at least three of the following categories:
upper case letters, lower case letters, numbers, and special characters.) in order to increase the
security of your product. And we recommend you reset your password regularly, especially in the
high security system, resetting the password monthly or weekly can better protect your product.
Step 4 Click OK to finish the acitavting of the IP camera. And the security status of camera will be
changed to Active.
2.3.2 Adding the Online IP Cameras
Purpose:
The main function of the NVR is to connect the network cameras and record the video got from it.
So before you can get a live view or record of the video, you should add the network cameras to
the connection list of the device.
Before you start:
Ensure the network connection is valid and correct. For detailed checking and configuring of the
network, please see Chapter Checking Network Traffic and Chapter Configuring Network Detection.
Adding the IP Cameras
OPTION 1:
Step 1 Click to select an idle window in the live view mode.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
