DS-7700NI-SP/9000/9600 Series HDVR/NVR User’s Manual
106
Figure 113 Rebuild Array Interface
3. Select the available physical disk and click OK to confirm to rebuild the array.
4. There will pop up an attention box with these words: Do not unplug the physical disk when it is
under rebuilding. Click OK to start rebuilding.
5. You can enter the Array Settings interface and Virtual Disk interface to view the rebuilding status.
6. After rebuilding successfully, the array and virtual disk will restore to Functional.
Note:
At least one available physical disk should exist for rebuilding the array.
Note:
It is recommended to enable the Auto-rebuild function and set the hot spare disk for automatically
rebuilding the array
Repairing Virtual Disk
When the disk cannot display in the HDD Information interface while the virtual disk can still show in the
Array Settings interface, you have to repair the virtual disk.
Note:
If the virtual disk is under foreground initialization, the repairing cannot be done.
To repairing virtual disk:
1. Enter the Virtual Disk interface by going to Menu > System Configuration > RAID > Virtual
Disk
Figure 114 Virtual Disk Interface
To Next Page
Loading...
Need help?
General