DS-7700NI-SP/9000/9600 Series HDVR/NVR User’s Manual
88
Configuring Cameras
Adding and Removing IP Cameras
Depending on the model of your DVR, IP cameras can be setup and used in conjunction with regular
analog cameras.
Before configuring IP cameras, please ensure the network settings for your DVR is properly setup.
To manage IP cameras:
1. Enter the Cameras menu by going to Menu > Cameras Setup > Cameras.
2. Select the IP Camera tab, as shown in Figure 89
Figure 89 IP Camera Configuration Menu
3. Click the Refresh button to automatically detect connected IP cameras on the network.
4. Check the checkbox of certain detected cameras to add. The basic information of the selected
camera will display on the left side of the interface.
5. If the password of the selected IP camera is default, you can click Quick Add to add the camera.
Otherwise enter the password in the Camera Password box on the left side. You can also edit the
basic parameters of the selected camera by click before you add it or directly edit it on the
left side of the interface.
6. Click the Upgrade button to upgrade the firmware of added IP cameras in local menu .
7. Click Protocol to pop up a Protocol Management box, as shown in Figure 90, to edit the protocol
parameters.
To Next Page
Loading...
Need help?
General