DS-7700NI-SP/9000/9600 Series HDVR/NVR User’s Manual
42
1. Enter the Exceptions menu by going to Menu > System Configuration > Exceptions
2. Check the checkbox to enable event hint, as shown in figure 35.
Figure 35 Event Hint Setting Menu
3. Select the Event Type Settings to configure. The event types include:
HDD Full: If selected, display event information when HDD is full.
HDD Error: If selected, display event information when errors on the HDD are detected.
Network Disconnected: If selected, display event information when a network disconnected is
detected.
IP Conflicted: If selected, display event information if an IP conflicted is detected.
Illegal Login: If selected, display event information when illegal logins are detected.
Video Exception: if selected, display event information when video signal is abnormal.
Input/Output Video Standard Mismatch: If selected, display event information when video
output standard does not match.
Recording/Capture exception: If selected, display event information when recording/capture
exception is detected.
Video Signal Loss: If selected, display event information when video signal losses.
Alarm Input Triggered: If selected, display event information when alarm input is triggered.
Video Tamper Detected: If selected, display event information when detects video tampering.
Motion Detection: If selected, display event information when detects motion in video.
IP Camera Conflicted: If selected, display event information when IP cameras conflict with
others.
Device Temperature Exception: If selected, display event information when device temperature
is abnormal.
Hot Spare Exception: If selected, display event information when hot spare function is abnormal.
All: if selected, trigger action when any one of events above is detected.
4. Select the Apply button to save the exception settings and select to return to the previous
menu. Selecting without clicking Apply will quit out of the menu without saving settings.
Select the Apply button to save the exception settings and select to return to the previous menu.
Selecting without clicking Apply will quit out of the menu without saving settings.
To Next Page
Loading...
Need help?
General