DS-7700NI-SP/9000/9600 Series HDVR/NVR User’s Manual
95
Figure 99 Video Tamper-proof Detection Menu
2. Select the camera to setup video tampering detection in using the camera dropdown list.
3. Check the Enable Tamper-proof checkbox.
4. Adjust the Sensitivity for video tampering detection.
5. Using the mouse, select the region on the preview screen for where you would like to enable
tamper-proof on. Press the Clear button to clear region.
6. Press the Handing Set button to set up handing method.
1) Select the Arming Schedule tab to set the arming schedule. Up to 8 periods can be
configured. If the same schedule can be applied in other days, click Copy.
2) Select the Handing tab to set the actions to take if tamper-proof is detected. The detail
instruction of the actions, please refer to Page 79.
3) Click Apply to save the settings. Click OK to back to the previous menu.
7. If the same settings can be applied in other channels, click Copy to copy the same configuration
to other channels.
8. Click Apply to save the settings.
To Next Page
Loading...
Need help?
General