HIKVISION DS-K1A802A Series - Page 89

Set Aendance Status
You can set the aendance mode on the device via the client. You can also set the aendance
parameters as check in, check out, break out, break in, overme in, and overme out on the device
according to your actual needs.
Note
This funcon should be supported by the device.
Disable Aendance Mode
Disable the aendance mode and the system will not display the aendance status on the device
inial page.
Before You Start
Add at least one person, and set the person's
authencaon mode. For details, see Person
Management .
Steps
1.
Click Access Control → Advanced
Funcon → More Parameters to enter the More Parameters
page.
2.
Select a device from the
le panel.
3.
Click Aendance Status.
4.
Set the aendance mode as Disable.
5.
Click Save.
Result
The aendance status funcon is disabled, and you will not view or congure the aendance
status on the device inial page.
Set Manual
Aendance
Set the aendance mode as manual, and you can select a status manually when you take
aendance on the device.
Before You Start
Add at least one person, and set the person's authencaon mode. For details, see Person
Management .
Steps
1.
Click Access Control → Advanced Funcon → More Parameters to enter the More Parameters
page.
2.
Select a device from the
le panel.
DS-K1A802A Series Fingerprint Time Aendance Terminal User Manual
72