Access Control Terminal·User Manual
114
2. Click on the icon on the Status Information panel to select a
door.
3. Click on the button listed on the upper-left side of the Status Information
panel to select a door status for the door.
: Click on the button to open the door once.
: Click on the button to close the door once.
: Click on the button to keep the door open.
: Click on the button to keep the door closed.
: Click on the button to capture the picture.
4. You can also right click the icon and to select a status for the
door.
If the status is selected as Remain Open/Remain Closed, the door will
keep open/ closed until a new anti-control command being made.
The function of picture capturing cannot be realized until the storage
server is installed.
Models DS-K1T802M and DS-K1T802E do not support the picture
capturing function.
Group Anti-control
Purpose:
You can control the status for a group of control points (doors) in this section.
Steps:
1. Enter the status monitor page.
2. Right click on a group in the Group list and to select a door status for the
group.
To Next Page
Loading...
