Access Control Terminal·User Manual
8
4 Installation
Before you start
Please make sure that the device in the package is in good condition
and all the assembly parts are included.
Make sure that all the related equipment is power-off during the
installation.
Check the specification of the products for the installation
environment.
Check whether the power supply is matched with your AC outlet to
avoid damage.
If the product does not function properly, please contact your dealer
or the nearest service center. Do not disassemble the camera for
repair or maintenance by yourself.
Please make sure the wall is strong enough to withstand three times
the weight of the device and the mounting.
4.1 Mounting with Gang Box
Steps:
1. Route the cables through the cable hole of the mounting base.
2. Align the screw holes on mounting base with the screw holes on
gang box.
3. Fix the mounting base on the gang box with inserting two
KA4*22-SUS screws (supplied) into the two screw holes.
To Next Page
Loading...
Need help?
General
