Access Control Terminal·User Manual
123
The Fingerprint Machine is for Access Control system to collect fingerprints.
Models DS-K1T802M and DS-K1T802E do not support the fingerprint machine
funciton.
Manual Capture Configuration
The Manual Capture Configuration is for Access Control system to take photos
remotely.
Models DS-K1T802M and DS-K1T802E do not support the manual capture
configuration.
Auto Time Synchronization
Steps:
1. Open the System Configuration page.
2. Click the Common tab to enter the Common Settings interface.
3. Tick the checkbox to enable Auto Time Synchronization.
4. Select the matched day and input the time to operate the time
adjustment.
5. Click the Save button to save the settings.
You can click the Restore Default Value button to restore the defaults of
all the local configurations.
Card Dispenser Configuration
Purpose:
The Card Reader Configuration of the Access Control System can configure
device type, connection mode, serial port, baud rate and other parameters of
the Card Reader Configuration.
Steps:
1. Click the icon on the System Configuration interface to
open the Card Dispatcher Configuration page.
To Next Page
Loading...
