HIKVISION DS-KD8003-IME2 - Page 14

Time
Click Time to enter the device me sengs page.
Figure 1-9 Synchronize Time
Select Time Zone or Enable NTP. Click Save to save the me sengs.
•
Time Zone
-
Select a me zone from the drop-down list menu.
-
Click the Synchronizaon.
•
NTP
-
Check the checkbox of Enable NTP to enable NTP.
-
Enter the server address, NTP port, and synchronizaon interval.
•
DST
-
Check the checkbox of Enable DST to enable DST.
-
Enter the start
me and end me of DST, and set the DST bias.
Note
The default port No. is 123.
System Maintenance
Click System Maintenance to enter the page.
Module Door
Staon Conguraon Guide
6