HIKVISION DS-KD9203 Series - Page 53

Figure 7-15 Door Parameters
2.
Select the door and edit the door name.
3.
Set Relay Reverse.
4.
Set Open
Duraon.
5.
Click Save to enable the sengs.
Card Security
Go to Access Control → Card Security to enter the sengs page.
Slide to enable card encrypon parameters and CPU card reading content. Click Save to enable the
sengs.
Elevator Control
Before You Start
●
Make sure your door
staon is in the mode of main door staon. Only the main door staon
support elevator control funcon.
●
Make sure your door staon has been connected to the elevator controller via RS-485 wire if you
want to use RS-485 interface.
Steps
1.
Click Access Control → Elevator Control to enter the corresponding conguraon page.
Video Intercom Face Recognion Door Staon User Manual
42