HIKVISION DS-PHA20-W2P

4. Use the
acvaon user name and password to login.
Note
Refer to Acvaon chapter for the details.
5.6.1 Add/Edit/Delete Tag (Card)
You can add tag to the security control panel and you can use the tag(card) to arm/disarm the
zone. You can also edit the tag informaon or delete the tag from the security control panel.
Steps
1. In the client
soware, select the device on the Device Management page and click , or enter
the device IP address in the address bar of the web browser and log in.
2. Click Conguraon → User Management → Tag to enter the management page.
3. Click Add to enter the adding page.
4. Select the linked keypad.
5. Click OK and the card(tag)
informaon will be displayed in the list.
Note
The card supports at least 20-thousand serial numbers.
6. Oponal: Click and you can change the card(tag) sengs, including tage(card) type, related
net user, linked area, etc.
7.
Oponal: Click to delete the card(tag).
5.6.2 Add/Edit/Delete Keyfob
You can add keyfob to the security control panel and you can control the security control panel via
the keyfob. You can also edit the keyfob informaon or delete the keyfob from the security control
panel.
Steps
1. In the client
soware, select the device on the Device Management page and click , or enter
the device IP address in the address bar of the web browser and log in.
2. Click
Conguraon → User Management → Keyfob to enter the Keyfob Management page.
Hybrid Security Control Panel User Manual
92