HIKVISION DS-PHA20-W2P

4.2.1 Communicaon Sengs
Wired Network Sengs
You can set the device IP address and other network parameters.
Steps
Note
Funcons varied depending on the model of the device.
1. In the client soware, select the device on the Device Management page and click , or enter
the device IP address in the address bar of the web browser and log in.
2. Click
Conguraon → Communicaon Parameters → Ethernet to enter the page.
Figure 4-1 Wired Network Sengs Page
3. Set the parameters.
-
Automac Sengs: Enable DHCP and set the HTTP port.
-
Manual
Sengs: Disabled DHCP and set IP Address, Subnet Mask, Gateway Address, DNS
Server Address.
Note
By default, the HTTP port is 80, which is not editable.
Hybrid Security Control Panel User Manual
10