HIKVISION DS-PHA20-W2P

Figure 4-32 Edit Keyfob
7. Set the keyfob name.
8. Select the keyfob linked area and related net user.
9. Enable Silence the Panic Alarm according to your needs.
Silence the Panic Alarm
When enabled, the panic alarm of the wireless keypad will have no linkage prompt.
10.
Oponal: Click to delete the keyfob.
Add/Edit/Delete Tag (Card)
You can add tag to the security control panel and you can use the tag(card) to arm/disarm the
zone. You can also edit the tag informaon or delete the tag from the security control panel.
Steps
1. In the client soware, select the device on the Device Management page and click , or enter
the device IP address in the address bar of the web browser and log in.
2. Click
Conguraon → User Management → Tag to enter the management page.
3. Click Add to enter the adding page.
4. Select the linked keypad.
5. Click OK and the card(tag)
informaon will be displayed in the list.
Note
The card supports at least 20-thousand serial numbers.
Hybrid Security Control Panel User Manual
50