HIKVISION DS-PHA20-W2P

Appendix G. Communicaon Matrix and Device
Command
Communicaon Matrix and Device Command
Scan the following QR code to get the device communicaon matrix and device common serial
port commands.
Note that the matrix contains all communicaon ports of Hikvision security control devices.
Figure G-1 QR Code of Communicaon Matrix and Device Command
User Privacy Statement
• The debug or zhimakaimen command is used to control access to the le system to ensure
device security. To obtain this permission, you can contact technical support.
• The device has admin, installer, maintenance, operator account. You can use these accounts to
access and
congure the device.
Table G-1 User Privacy
Informaon Descripon
Password The password for the device account, used to
log in to the device.
Username The username for the device account, used to
log in to the device.
Device IP and port The device IP and port are used to support
network service communicaon. For details,
refer to Communicaon Matrix.
Log Used to record informaon such as device
operang status and operaon records.
Database informaon Used to record informaon.
Hybrid Security Control Panel User Manual
118