HIKVISION DS-PHA20-W2P

5.4 Use the Card
It is poissible to arm or disarm the system with the card.
While the system is not armed, present a valid card to the control panel to arm the system.
While the system is armed, present a valid card to the control panel to disarm the system.
5.5 Use the Client Soware
Steps
1. Download, install and register to the client soware.
2. Add device in Device Management → Device .
Note
• Set the device port No. as 80.
• The user name and password when adding device are the
acvaon user name and
password.
3. Click to enter the Remote Conguraon page aer the device is completely added,
5.5.1 Add Device to the Client
Soware
Before You Start
Acvate the device and ensure that the device is on the same subnet as the PC.
Figure 5-4 Client Soware Main Page
In the client soware, go to Device Management → Device on the Maintenance and Management
list. You can add devices to client
soware by several methods on the device management page.
Hybrid Security Control Panel User Manual
88