HIKVISION DS-PHA20-W2P

Local Log Search
You can search the log on the device.
In the client
soware, select the device on the Device Management page and click , or enter
the device IP address in the address bar of the web browser and log in. Click Conguraon →
System → Log to enter the Local Log Search page.
Figure 4-40 Local Log Search Page
Select a major type and a minor type from the drop-down list, set the log start me and end me
and click Filter. All ltered log informaon will be displayed in the list.
You can also click Reset to reset all search condions.
4.2.8 Check Status
Aer seng the zone, relay, and other parameters, you can view their status.
Click Device Status. You can view the status of zone, relay, sounder,
baery, communicaon, and
repeater.
• Zone: You can view the zone status, alarm status, detector baery capacity, and signal strength.
• Area: You can view area status.
• Sounder: You can view sounder status,
baery status, and signal strength.
• Relay: You can view relay status and signal strength.
•
Baery: You can view the baery charge.
•
Communicaon: You can view the wired network status, Wi-Fi status, Wi-Fi signal strength,
cellular network status, used data, and cloud connecon status.
For more
operaon in this page, refers to Use the Web Client .
Hybrid Security Control Panel User Manual
62