HIKVISION DS-PHA20-W2P

If the opon is enabled, the alarm will be triggered when the RS-485 bus of device has
excepon.
AC Power Down Check Time
The system checks the fault aer the congured me duraon aer AC power down.
To compliant the EN 50131-3, the check me duraon should be 10 s.
System Maintenance
On the device list page, tap the security control panel and then log in to the device (if required) to
enter the control panel page.
Tap → System Maintenance to set parameters.
Reboot Device
The device will restore all parameters to the default
sengs.
Partly Restore
The device will restore to its default sengs except for admin user informaon, wired network
parameters, Wi-Fi network, detector informaon, and wireless device parameters.
Public Area Conguraon
On the device list page, tap the security control panel and then log in to the device (if required) to
enter the control panel page.
Tap → Area Management → Public Area Conguraon to set parameters.
Figure 4-47 Public Area Conguraon
Aer slide Enable, the area 1 will be regarded as the public area.
You can select linked area as well.
Hybrid Security Control Panel User Manual
72