213960EN(1) - P290 Mattress Instructions for Use Page 23
Installing
the Patient
10. Connect the hose to the control unit.
The connector clicks when correctly in position
.
11. Make sure that the hose cable does not become
entangled in the barriers of the bed. Where
appropriate, place the cable on the handrail
panel footboard.
12. Connect the power cord to the control unit.
13. Make sure that the power cord does not
become entangled in the barriers of the bed.
14. Use the strap loops (on the right of the device)
and the Velcro® straps provided to keep the
entire length of the device in place.
15. Connect the power cord to the wall outlet.
With articulated frames, make sure that the power cord is not attached to any
mobile parts, nor jammed anywhere to prevent it from being cut.
To Next Page
Loading...
