213960EN(1) - P290 Mattress Instructions for Use Page 45
Accessories /
Parts
Installing the Seat Cushion
1. Switch the mattress in transport mode (see “Moving the Patient on the Bed in
Transport Mode” on page 31).
2. Place the seat cushion at the foot of the bed.
3. Open the flap (A) on the seat cushion, disconnect and stretch the spiral hose (B).
4. Connect the adaptor (C) between the spiral hose and the control unit.
A click confirms the connection.
5. Connect the control unit to the mains.
The device automatically inflates to the maximum (P-max) so as to fully develop
the air cushions. When he returns to the default mode "Alternating Pressure Low",
the cushion is ready.
Identification labels Packaging labels
To Next Page
Loading...
