HIMA HIMatrix F3 DIO 16/8 01 - Overview of Configuration Variants for the Digital Outputs; Pulsed Outputs; Table 19: Configuration Variants for the Digital Outputs; Table 20: Terminal Assignment for the Pulsed Outputs

F3 DIO 16/8 01 4 Start-Up
HI 800 177 E Rev. 1.01 Page 31 of 58
4.1.3.1 Overview of Configuration Variants for the Digital Outputs
The following table specifies all configurations variants for the digital outputs permitted for
ELOP II Factory. Additional system signals have no influence on other variants (e.g., Signal
DO[xx].LS monitoring with reduced voltage). With improper parameter setting, a diagnostic
entry (IOA Wrong Initial Data) is generated. Simultaneously, the parameter setting is
displayed. Use the table below to locate errors.
Configuration Variants for the Digital Outputs
Application
Channel 1
two-pole
Channel 2
two-pole
Channel 1
LSLB
Channel 2
LSLB
Common
ground
One-pole
X
1)
X
1)
X
1)
X
1)
X
1)
X
1)
X
1)
X
1)
X
1)
X
1)
X
1)
X
1)
X
1)
X
1)
Two-pole
X
1)
X
1)
X
1)
X
1)
X
1)
X
1)
X
1)
X
1)
X
1)
X
1)
X
1)
X
1)
X
1)
X
1)
X
1)
Three-pole
X
1)
X
1)
X
1)
X
1)
X
1)
1)
Option is selected
Table 19: Configuration Variants for the Digital Outputs
4.1.4 Pulsed Outputs
Terminal assignment for the pulsed outputs.
Terminal Designation Function (non-safe pulsed outputs TO)
25 1 Pulsed output 1
26 1 Pulsed output 1
27 1 Pulsed output 1
28 1 Pulsed output 1
29 2 Pulsed output 2
30 2 Pulsed output 2
31 2 Pulsed output 2
32 2 Pulsed output 2
Table 20: Terminal Assignment for the Pulsed Outputs