F3 DIO 16/8 01 4 Start-Up
HI 800 177 E Rev. 1.01 Page 39 of 58
4.3.4 Pulsed Outputs for F3 DIO 16/8 01
The following table presents the statuses and parameters for the pulse module (DO 2 01) in
the same order given in the SILworX Hardware Editor.
4.3.4.1 Module Tab
The Module tab contains the following system parameters.
System Signal
Data
type
R/W Description
DO.Error Code WORD R Module error code
Coding Description
0x0001 Error of the TO unit as a whole:
Module Error Code WORD R Module error code
Coding Description
0x0000
I/O processing, if required with errors, see
other error codes
0x0001 No I/O processing (remote I/O not in RUN)
0x0002 No I/O processing during the booting test
0x0004 Manufacturer interface operating
0x0010 No I/O processing: wrong configuration
0x0020 No I/O processing: fault rate exceeded
0x0040/
0x0080
No I/O processing: configured module not
plugged in
Module SRS UDINT R Slot number (System Rack Slot)
Module Type UINT R Type of module, target value: 0x00D3 [211
dec
]
Table 25: SILworX - System Parameters for Pulsed Outputs, Module Tab
4.3.4.2 DO 2 01: Channels Tab
The DO 2 01: Channels tab contains the following system parameters.
System Signal
Data
type
R/W Description
Channel no. --- R Channel number, defined by default
-> Error Code [BYTE] WORD R Error code of the individual digital pulsed output channels:
Coding Description
0x01 Fault in the digital output module
Value [BOOL] -> BOOL R Output value for TO channels:
Coding Description
FALSE Output de-energized
TRUE Output energized
Do not use pulsed outputs as safety-related outputs!
Table 26: SILworX - System Parameters for Pulsed Outputs, Module Tab
To Next Page
Loading...
