HIMA HIMatrix F3 DIO 16/8 01 - Configuring a Module Using ELOP II Factory; Configuring the Inputs and Outputs; Signals and Error Codes for the Inputs and Outputs

4 Start-Up F3 DIO 16/8 01
Page 40 of 58 HI 800 177 E Rev. 1.01
4.4 Configuring a Module Using ELOP II Factory
4.4.1 Configuring the Inputs and Outputs
The signals previously defined in the Signal Editor (Hardware Management) are assigned
to the individual channels (inputs and outputs) using ELOP II Factory. Refer to the System
Manual for Compact Systems or the online help for more details
The following chapter describes the system signals used for assigning signals in the
remote I/O.
4.4.2 Signals and Error Codes for the Inputs and Outputs
The following tables specify the system signals that can be read and set for the inputs and
outputs, including the corresponding error codes.
In the user program, the error codes can be read using the signals assigned within the
logic.
The error codes can also be displayed in ELOP II Factory.