HIMA HIMatrix User Manual

Table of Contents F3 DIO 16/8 01
Page 4 of 60 HI 800 177 E Rev. 2.00
4 Start-up 29
4.1 Installation and Mounting 29
4.1.1 Installation and Terminals of the Digital Inputs 29
4.1.2 Surges on Digital Inputs 30
4.1.3 Installation and Terminals of the Digital Inputs 30
4.1.3.1 Overview of Configuration Variants for the Digital Outputs 31
4.1.4 Pulsed Outputs 31
4.1.5 Cable Plugs 32
4.1.6 Mounting the F3 DIO 16/8 01 in Zone 2 33
4.2 Configuration 34
4.3 Configuration with SILworX 34
4.3.1 Parameters and Error Codes for the Inputs and Outputs 34
4.3.2 Digital Inputs of F3 DIO 16/8 01 34
4.3.2.1 Tab: Module 35
4.3.2.2 Tab: DI 16 LC: Channels 36
4.3.3 Digital Outputs of F3 DIO 16/8 01 37
4.3.3.1 Tab: Module 37
4.3.3.2 Tab: DO 8 03: Channels 39
4.3.4 Pulsed Outputs for F3 DIO 16/8 01 40
4.3.4.1 Tab: Module 40
4.3.4.2 Tab: DO 2 01: Channels 40
4.4 Configuration with ELOP II Factory 41
4.4.1 Configuring the Inputs and Outputs 41
4.4.2 Signals and Error Codes for the Inputs and Outputs 41
4.4.3 Digital Inputs of F3 DIO 16/8 01 42
4.4.4 Digital Outputs of F3 DIO 16/8 01 43
4.4.5 Pulsed Outputs for F3 DIO 16/8 01 45
4.5 Configuration of Line Diagnosis 46
4.5.1 Line Diagnosis for Lamp Loads and Inductive Loads 46
4.5.2 Line Diagnosis for Ohmic, Capacitive Loads 46
4.6 Connection Variants 47
4.6.1 1-Pole Connection 47
4.6.2 2-Pole Connection 48
4.6.3 2-Pole Connection to Common Ground (3-pole Connection) 49
5 Operation 50
5.1 Handling 50
5.2 Diagnosis 50
5.2.1 Diagnostic Entries 50
6 Maintenance 51
6.1 Faults 51
6.2 Maintenance Measures 51
6.2.1 Loading the Operating System 51
6.2.2 Proof Test 51

HIMA HIMatrix Specifications

General

Brand	HIMA
Model	HIMatrix
Category	Controller
Language	English