1.2 RS-232C Communications
7
2
3
4
5
6
7
8
9
11
1
1.2.2 RS-232 Settings
Remote control is provided by commands sent from the controlling
PC. RS-232C settings are made on the instrument. These settings
must match those on the PC to enable communications.
• If overrun or framing errors occur, reduce the communications
speed.
• Do not attempt change settings while communications are
underway.
Display the Status Screen.
Move the blinking cursor to the position shown.
Display the Copy&Comm Screen.
Display the Comm Window.
Move the blinking cursor to the position shown.
Select "RS-232C" for the Communications Interface.
Select each settings.
Items Settings
Baud Rate 1200 to 19200 bps
Data Bits 7 bit/ 8 bit
Parity None/ Even/ Odd
Stop Bits 1 bit/ 2 bit
Delimiter LF/ CR+LF
Header OFF/ ON
Flow Control None/ X-on/X-off/ Hardware
To Next Page
Loading...
