Hioki 8420-51 - Sending Mail; Sending Mail Via 10 BASE-T LAN

64
1.8 Sending Mail
When such events as a start or stop trigger, alarm, start backup,
memory full, or card full occur during measurement with this instru-
ment, e-mail can be sent via a SMTP mail server to PCs within the
network or at remote locations, or to cellular phones capable of
handling e-mail. (The 8993 DIGITAL I/O UNIT is required for
alarms. Alarms that occur frequently will result in mail being sent
frequently. In such case, turn the alarm hold function on so that
mail will only be sent for the first alarm on each alarm channel.)
Up to three recipient addresses can be registered.
1.8.1 Sending Mail via 10BASE-T LAN
1. Set parameters for the LAN on the instrument.
❖ See Section 1.3.1 to Section 1.3.5.
2. Set parameters for communications on the instrument.
❖ See Section 1.8.1.
3. Carry out email transmission via the instrument.
❖ See Section 1.8.3 to Section 1.8.5.
4. When measurement is underway on the instrument and a trigger
or alarm is activated, an email is sent via email server.
1.8 Sending Mail
Memory HiLogger
Mail-receiving PC
SMTP
mail server
(e.g., 192.168.1.2) (e.g., 192.168.1.1)
(e.g., 192.168.1.100)
Internet service
provider
Mail-receiv-
ing cellula
r
phone or PC