20
1.3 10BASE-T LAN Communications
1.3.5 LAN Settings
Host Name And IP Address Settings
To connect the instrument to a LAN network, you need to set the
host name of the instrument, IP address, subnet mask, port num-
ber, and gateway.
When connecting to an existing network, the specification items
must first be assigned by the network system manager (depart-
ment manager). Make sure they never overlap with another
machine.
You will ne-ed to obtain the following from your network administra-
tor.
Host Name ____________ (up to 12 characters)
DHCP server (yes or no)
IP Addresses
*1
___.___.___.___
Subnet Mask
*1
___.___.___.___
Port No. (When the default, 8800-8809, cannot be used.)
(Specify the first three of four decimal columns, and 0 to 9 in the first column
is used and reserved by this machine.)
___X
Default gateway
*2
(yes or no)
Gateway IP addresses (There is a Gateway.)
*2
___.___.___.___
DNS server
*3
(yes or no)
DNS server IP address (There is a DNS server.)
*3
___.___.___.___
*1: Skip setting if you use DHCP.
*2: Skip setting if you can obtain gateway information with DHCP.
*3: Skip setting if you can obtain DNS information with DHCP.
Host Name
This is the name of the instrument in the network. It must be dis-
tinct from the addresses of all other devices in the network.
To Next Page
Loading...
