74
1.10 PPP (RS-232C + Modem) Settings on PC Side
1.10.1 Calling from PC to the Instrument
The following functions can be used by making calls from PCs to
this instrument using PPP (RS-232C + modem) via public switched
networks or cellular phones.
• Remote operation by HTTP server
❖ For settings on the instrument side:
See Section 1.5 "Remote Measurement Using HTTP Server" (33 page.)
• Manual data acquisition by FTP server
(Settings on this instrument side are the same as for HTTP.)
❖ See Section 1.6 "Downloading Data to a PC via FTP Server" (43 page.)
• Real-time measurement by the 9334 LOGGER COMMUNICA-
TOR
❖ For settings on the instrument side:
See Section 1.9 "Measurement with the 9334 LOGGER COMMUNICA-
TOR" (71 page.)
❖ See the 9334 LOGGER COMMUNICATOR (option) Instruction Manual.
(Pay attention to telephone charges because the telephone
remains connected during measurement. Because the modem
communication speed is limited, measurement may not be possi-
ble at speeds faster than a one-second recording interval.)
• Measurement using a program created in Visual Basic, etc.
❖ See the Interface Manual on the Application Disk (CD-R).
The connecting IP address when a telephone message is being
received is 192.168.55.2 for this instrument, and 192.168.55.1 for
the PC.
"Current IP Address" indicates the IP address actually assigned to
this instrument.
Before dialing a number from the PC to this instrument, make sure
that dial-up connections have been set up on the PC side. Dial-Up
Networking is included with Windows, so refer to Windows HELP.
For details on how to add a modem to Windows, refer to the user's
manual supplied with your modem.
1.10 PPP (RS-232C + Modem) Settings on PC
Side
To Next Page
Loading...
