Hioki 8420-51 - Page 41

1.5 Remote Measurement Using HTTP Server
35
2
3
4
5
6
7
8
9
10
11
1
Comm Window (PPP 2/5)
1. Receipt Account:
Set the user name (e.g., logger) to be entered at PC dial-up con-
nection.
❖ See Section 1.10.1 "Calling from PC to the Instrument" (74 page.)
2. Receipt Password:
Set the password (e.g., logger) to be entered at PC dial-up con-
nection.
❖ See Section 1.10.1 "Calling from PC to the Instrument" (74 page.)
3. Disconnect Timeout:
When no communication is performed, the instrument waits the
time set here before disconnecting.
4. AT Command:
If necessary, the AT command can be specified for the modem
as an option.
When cellular phones are used, for example, the command for
specifying data communication may be necessary.
❖ See Section 1.4 "PPP (RS-232C + Modem) Communications" (24 page.)
❖ For details of the commands, see the Instruction Manual of your modem.
5. Port, Delimiter, Header:
Specify the port number used by this instrument.
❖ See Section 1.3.5 "LAN Settings" (20 page.)
6. Baud Rate (Slow down if you cannot communicate.)
Comm Window (PPP 2/5)