1.7 Automatic Data Transfer by FTP Client
51
2
3
4
5
6
7
8
9
11
1
Comm Window (PPP 1/5, 4/5, 2/5)
1. Set the FTP server name and FTP server IP address as shown
below. Other settings are the same as when communicating via
a LAN.
Specify the PC on which the FTP server operates.
To send to the PC, normally set "Telephone."
"Telephone" Specify the PC at the Telephone.
"IP Address" Specify the server by IP.
"Server Name" Specify the server by host name. (DNS is
required.)
2. FTP Dial Number:
Set the telephone number on the PC side at the connected des-
tination.
3. Connect Account:
Set the user name (e.g., logger) to be entered in the PC's
remote access server (i.e., remote access server, dial-up
server.)
❖ See Section 1.10.8 "Calling from the Instrument to PC" (90 page.)
4. Connect Password:
Set the password (e.g., logger) to be entered in the PC's remote
access server (i.e., remote access server, dial-up server.)
❖ See Section 1.10.8 "Calling from the Instrument to PC" (90 page.)
5. DNS:
To use the DNS at the connected destination, select ON for this
item.
6. IP address of DNS:
To use the DNS at the connected destination, set the IP address
of the DNS.
7. Retry Count, Retry Interval:
If the call cannot be connected, the number is redialed (after
waiting the specified retry interval) as many times as specified
by the retry count.
8. AT Command:
If necessary, the AT command can be specified for the modem
as an option.
❖ See Section 1.4.2 "PPP (RS-232C + Modem) Settings" (27 page.)
❖ For details of the commands, see the Instruction Manual of your modem.
9. Baud Rate (Slow down if you cannot communicate.)
To Next Page
Loading...
