Hioki 8420-51 - Page 73

1.8 Sending Mail
67
2
3
4
5
6
7
8
9
10
11
1
Comm Window (PPP 1/5, 3/5, 2/5)
1. Set the mail server name and mail server IP address as shown
below. Other settings are the same as when communicating via
a LAN. When sending to the Internet service provider, you nor-
mally need to specify the server name.
"Telephone" Specify the PC at the Telephone.
"IP Address" Specify the server by IP.
"Server Name" Specify the server by host name. (DNS is
required.)
2. Mail Dial Number:
Set the telephone number of the Internet service provider to
which mail is connected or the telephone number on the PC
side.
3. Connect Account:
Set the user name of the Internet service provider or user name
(e.g., logger) to be entered in the PC's remote access server
(i.e., Incoming Connections, dial-up server.)
❖ See Section 1.10.8 "Calling from the Instrument to PC" (90 page.)
4. Connect Password:
Set the password of the Internet service provider or password
(e.g., logger) to be entered in the PC's remote access server
(i.e., Incoming Connections, dial-up server.)
❖ See Section 1.10.8 "Calling from the Instrument to PC" (90 page.)
5. DNS:
To use the DNS at the connected destination, select ON for this
item.
6. IP Address of DNS:
To use the DNS at the connected destination, set the IP address
of the DNS. (For one DNS, set its IP address at No. 1; for two
DNSs, set their IP addresses at No. 1 and No. 2.)
7. Retry Count, Retry Interval:
If the call cannot be connected, the number is redialed (after
waiting the specified retry interval) as many times as specified
by the retry count.
8. AT Command:
If necessary, the AT command can be specified for the modem
as an option.
❖ See Section 1.4.2 "PPP (RS-232C + Modem) Settings" (27 page.)
❖ See the Instruction Manual of your modem.
9. Baud Rate (Slow down if you cannot communicate.)
When the DNS is enabled, use the specified IP address other than
0.0.0.0. If the specified IP address is 0.0.0.0, use the IP address