Hioki PW3336 - Setting the VT Ratio

3.2 Configuring Settings
60
Setting the VT ratio
1 Press .
2 Press to display the setting
screen shown to the left.
3 Press or until the first digit of
the VT ratio for the channel you wish to
set flashes.
4 Press or to set the VT ratio.
To change digits:
Press or until the digit you wish to set
flashes and then set the digit.
To set the VT ratio for another channel:
Return to Step 3.
5 Press to exit the settings.
The instrument will revert to the normal measure-
ment state.