3.10 Other Functions
112
This section describes how to initialize the instrument’s settings. Initializing the instrument (performing a sys-
tem reset) reverts settings to their default values at the time the device was shipped from the factory. The sys-
tem reset should be performed while the self-test is in progress after turning on the instrument (before the
display changes to the normal display).
Example: PW3337-03
3.10.4Initializing the Instrument (System Reset)
• Disconnect any voltage or current input from the instrument before performing the reset.
• The RS-232C communications speed, GP-IB address, and LAN-related settings will not be initialized.
1 Turn on the instrument.
2 While the product model and ver-
sion are being displayed, press
and then .
(The SHIFT lamp will not light up.)
3 Perform zero-adjustment as you
would during normal operation.
If the system reset is being performed, the dis-
play will appear as shown below after the com-
pletion of zero-adjustment.
4 The System Reset screen will be
displayed, and settings will be
reverted to their default values
when the instrument was shipped
from the factory.
To Next Page
Loading...
