Installation BAT
Release
05
03/2013
11
2006/95/EC
Directive of the European Parliament and the council for standardizing the
regulations of member states with regard to electrical equipment to be
used within specific voltage ranges.
2004/108/EG (EMV)
Directive of the European Parliament and the council for standardizing the
regulations of member states with regard to electromagnetic
compatibility.
In accordance with the above-named EU directive(s), the EU conformity
declaration will be at the disposal of the relevant authorities at the
following address:
Hirschmann Automation and Control GmbH
Stuttgarter Str. 45-51
72654 Neckartenzlingen
Germany
Tel.: +49 1805 141538
The product can be used in living areas (living area, place of business,
small business) and in industrial areas.
Information on using devices in motor vehicles (e1)
Some variants of the devices are e1-certified. Only operate suitably
labeled products in motor vehicles.
Note: To fulfill the requirements of directive 1999/5/EG (R&TTE
directive) when operating the device in a motor vehicle:
Supply the voltage to the device via a Power-over-Ethernet (PoE)
switch or via a power
unit that conforms to IEEE 802.3af.
You will find information on Hirschmann PoE-capable switches under
http://www.hirschmann.com.
Or:
Install an upstream filter on the 24V DC voltage supply. You will find
information on suitable filters under
http://www.hirschmann.com.
Tip: If you are using an e1-certified device in a vehicle and want to be able
to drive the vehicle freely within the EU, set the country profile for
Germany. This country profile is identical to all the country profiles for EU
countries. Just be sure not to use any special frequencies, such as
BFWA.
To Next Page
Loading...
Need help?
General
