12
Installation BAT
Release
05
03/2013
FCC note:
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Important note:
This equipment complies with FCC and IC RSS-102 radiation exposure
limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 50 cm (19.7 in, applied to
a 23 dBi antenna) between the radiator and your body.
The antenna used for this transmitter must not be co-located with any
other transmitters within a host device, except in accordance with FCC
multi-transmitter product procedures.
This transmitter is restricted to indoor use only within the 5.15-5.25 GHz
band to reduce potential for harmful interference to co-channel mobile
satellite systems.
Note: The following paragraph is valid for the BAT300-…FCC devices
only:
The usage of the antennas BAT-ANT-N-9A-DS-IP65 and BAT-ANT-N-
MiMo5-9N-IP65 in the 5.15 - 5.25 GHz band is only permitted with an
attenuation of 3dB between antenna ports of the main unit and antenna.
Attenuation may be realized by a low loss cable such as Hirschmann
BAT-CLB-2N m-f (Order Number: 943 903-514).
To Next Page
Loading...
Need help?
General
