Hirschmann GigaLION-24TP - Configuring a MAC ACL Mask; Figure 3-37. ACL Mask Configuration - MAC

Configuring the Switch
3-62
3
Configuring a MAC ACL Mask
This mask defines the fields to check in the packet header.
Command Usage
You must configure a mask for an ACL rule before you can bind it to a port.
Command Attributes
• Source/Destination MAC – Use “Any” to match any address, “Host” to specify the
host address for a single node, or “MAC” to specify a range of addresses.
(Options: Any, Host, MAC; Default: Any)
• Source/Destination MAC Bitmask – Address of rule must match this bitmask.
• VID Bitmask – VLAN ID of rule must match this bitmask.
• Ethernet Type Bitmask – Ethernet type of rule must match this bitmask.
• Packet Format Bitmask – A packet format must be specified in the rule.
Web – Configure the mask to match the required rules in the MAC ingress or egress
ACLs. Set the mask to check for any source or destination address, a host address,
or an address range. Use a bitmask to search for specific VLAN ID(s) or Ethernet
type(s). Or check for rules where a packet format was specified. Then click Add.
Figure 3-37. ACL Mask Configuration - MAC