Authentication Commands
4-81
4
Command Usage
• The “max-count” parameter specified by this command is only effective if the
dot1x mode is set to “auto” by the dot1x port-control command (page 4-105).
• In “multi-host” mode, only one host connected to a port needs to pass
authentication for all other hosts to be granted network access. Similarly, a
port can become unauthorized for all hosts if one attached host fails
re-authentication or sends an EAPOL logoff message.
Example
dot1x re-authenticate
This command forces re-authentication on all ports or a specific interface.
Syntax
dot1x re-authenticate [interface]
interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
Command Mode
Privileged Exec
Example
dot1x re-authentication
This command enables periodic re-authentication globally for all ports. Use the no
form to disable re-authentication.
Syntax
[no] dot1x re-authentication
Command Mode
Global Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x operation-mode multi-host max-count 10
Console(config-if)#
Console#dot1x re-authenticate
Console#
Console(config)#dot1x re-authentication
Console(config)#
To Next Page
Loading...
