Hirschmann GigaLION-24TP - Ip Default-Gateway; Show Ip Interface

IP Interface Commands
4-213
4
Related Commands
ip address (4-211)
ip default-gateway
This command establishes a static route between this switch and management
stations that exist on another network segment. Use the no form to remove the static
route.
Syntax
ip default-gateway gateway
no ip default-gateway
gateway - IP address of the default gateway
Default Setting
No static route is established.
Command Mode
Global Configuration
Command Usage
A gateway must be defined if the management station is located in a different
IP segment.
Example
The following example defines a default gateway for this device:
Related Commands
show ip redirects (4-214)
show ip interface
This command displays the settings of an IP interface.
Default Setting
All interfaces
Command Mode
Privileged Exec
Example
Console(config)#ip default-gateway 10.1.1.254
Console(config)#
Console#show ip interface
IP address and netmask: 192.168.1.54 255.255.255.0 on VLAN 1,
and address mode: User specified.
Console#