Hirschmann GigaLION-24TP - Figure 3-40. Port - Port Configuration

Configuring the Switch
3-68
3
• Trunk – Indicates if a port is a member of a trunk. To create trunks and select port
members, see “Creating Trunk Groups” on page 3-69.
Note: Auto-negotiation must be disabled before you can configure or force the interface
to use the Speed/Duplex Mode or Flow Control options.
Web – Click Port, Port Configuration or Trunk Configuration. Modify the required
interface settings, and click Apply.
Figure 3-40. Port - Port Configuration
CLI – Select the interface, and then enter the required settings.
Console(config)#interface ethernet 1/13 4-123
Console(config-if)#description RD SW#13 4-124
Console(config-if)#shutdown 4-128
.
Console(config-if)#no shutdown
Console(config-if)#no negotiation 4-125
Console(config-if)#speed-duplex 100half 4-124
Console(config-if)#flowcontrol 4-127
.
Console(config-if)#negotiation
Console(config-if)#capabilities 100half 4-126
Console(config-if)#capabilities 100full
Console(config-if)#capabilities flowcontrol
Console(config-if)#exit
Console(config)#interface ethernet 1/21
Console(config-if)#combo-forced-mode copper-forced 4-128
Console(config-if)#