Hirschmann GigaLION-24TP - Figure 3-72. Default Port Priority

Configuring the Switch
3-126
3
Web – Click Priority, Default Port Priority or Default Trunk Priority. Modify the default
priority for any interface, then click Apply.
Figure 3-72. Default Port Priority
CLI – This example assigns a default priority of 5 to port 3.
Console(config)#interface ethernet 1/3 4-123
Console(config-if)#switchport priority default 5 4-191
Console(config-if)#end
Console#show interfaces switchport ethernet 1/5 4-133
Information of Eth 1/3
Broadcast threshold: Enabled, 500 packets/second
Lacp status: Disabled
Ingress rate limit: disable,1000M bits per second
Egress rate limit: disable,1000M bits per second
VLAN membership mode: Hybrid
Ingress rule: Disabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 5
Gvrp status: Disabled
Allowed Vlan: 1(u),
Forbidden Vlan:
Console#