Hirschmann GigaLION-24TP - Table 4-2. Configuration Command Modes

Command Line Interface
4-8
4
To enter the other modes, at the configuration prompt type one of the following
commands. Use the exit or end command to return to the Privileged Exec mode.
For example, you can use the following commands to enter interface configuration
mode, and then return to Privileged Exec mode
Table 4-2. Configuration Command Modes
Mode Command Prompt Page
Line line {console | vty} Console(config-line)# 4-11
Access
Control List
access-list ip standard
access-list ip extended
access-list ip mask-precedence
access-list mac
access-list mac mask-precedence
Console(config-std-acl)
Console(config-ext-acl)
Console(config-ip-mask-acl)
Console(config-mac-acl)
Console(config-mac-mask-acl)
4-86
Interface interface {ethernet port | port-channel id| vlan id} Console(config-if)# 4-123
VLAN vlan database Console(config-vlan) 4-170
MSTP spanning-tree mst-configuration Console(config-mstp)# 4-157
Console(config)#interface ethernet 1/5
.
.
.
Console(config-if)#exit
Console(config)#