Command Line Interface
4-68
4
Default Setting
None
Command Mode
Global Configuration
Command Usage
• A colon (:) is required after the specified file type.
• If the file contains an error, it cannot be set as the default file.
Example
Related Commands
dir (4-66)
whichboot (4-67)
Authentication Commands
You can configure this switch to authenticate users logging into the system for
management access using local or RADIUS authentication methods. You can also
enable port-based authentication for network client access using IEEE 802.1x.
Console(config)#boot system config: startup
Console(config)#
Table 4-26. Authentication Commands
Command Group Function Page
Authentication Sequence Defines logon authentication method and precedence 4-69
RADIUS Client Configures settings for authentication via a RADIUS server 4-70
TACACS+ Client Configures settings for authentication via a TACACS+ server 4-74
Port Security Configures secure addresses for a port 4-76
Port Authentication Configures host authentication on specific ports using 802.1x 4-78
To Next Page
Loading...
