22
Installation MACH104
Release
07
07/2014
2.2 Installing an SFP transceiver (optional)
Figure 10: MACH104 device, front view
1 - Ports 5 + 6: Two SFP slots that are used as alternatives to the RJ45
ports
2 - Ports 7 + 8: Two SFP slots that are used as alternatives to the RJ45
ports
Note: Only use SFP transceivers Hirschmann which are suitable for this
device. See “Accessories” on page 34.
Before installing an SFP transceiver or XFP transceiver, first remove the
protection cap of the transceiver.
Push the SFP transceiver or XFP transceiver with the lock closed into the
socket until you hear it latch in.
Figure 11: F/O SFP transceiver
2.3 Wiring and assembling the signal contact
Figure 12: 2-pin terminal block
To Next Page
Loading...
Need help?
General
