Hisun 700UTV - Engine; 2. Inspection and Adjustment of Engine; 2.1 Inspection of Cylinder Head, Intake and Exhaust Valve

11
Select lever safety
system cable
● Check operation.
● Adjust if necessary.
○ ○ ○
V-belt*
● Check operation.
● Check for cracks or damage.
○ ○ ○ ○
Wheel
● Check balance/damage/
● Repair if necessary.
○ ○ ○ ○
Wheel bearing*
● Check bearing assemblies for lossenss/
damage.
● Replace if necessary.
○ ○ ○ ○
Front and rear
suspendion*
● Check operation.
● Correct if necessary.
○ ○
Steering system*
● Checkoperation./Replace if damaged
● Check toe-in./Adjust if necessaly.
○ ○ ○ ○ ○
Drive shaft universal
joint*
● Lubricate with lithium–soap–bassed
grease.
○ ○ ○
Axle boots*
● Check operation.
● Replace if damaged.
○ ○ ○ ○ ○
Fittings and
fasteners*
● Check all chassis fittings and fastenrs.
● Correct if necessary.
○ ○ ○ ○ ○
Lights and
switches*
● Check operation.
● Adijust headinght beams.
○ ○ ○ ○ ○
Engine
2.
2. 2.
2. Inspection and adjustment of engine
2.1
2.1 2.1
2.1 Inspection of cylinder head, intake
and exhaust valve
Preheat the engine ,then misfire and unplug the spark plug.
Fix pressure gauge into the hole, open the choke and throttle
handle, and start for 4-6 times.
Note: Giving a leakage check to the pressure gauge.
Rotate the engine until the pressure gauge stop rising.
The maximum reading would be greater than 0.7-0.9Mpa