4、Assemble the parking handle onto the frame with two
pieces of M nuts.
5、Assemble the front of the parking cable onto the
parking handle.
6、Adjust the inner hexagon nuts until the rear brake
shoe exactly contact with the rear disk brake
plate,then finish the adjustment with lock the inner
hexagon nuts with spanner,
Attention:after the adjustment,the UTV can paking
stabilized in the 12 ° pitch with the fully
loaded.(The total quality is 920KG)
4.3 Wheel and Tyre parts
4.3.1 Preparation for maintenance of wheel.
1. Inspect the wear condition of the tyre. (Attached Figure
4-2-21)
Attached
Figure 4-2-21
To Next Page
Loading...
