Check if the Wheel Hub is worn-out or damaged.(Attached
Figure 4-2-21)
3. Check if the Wheel Hub is rusted or cracked.
4.
Check if the conical nuts of the Wheel Hub are loosen or
distorted.
4.3.2 Disassembly, inspection and assembly of wheel
components.
4.3.2.1 Disassembly of wheel components
Remove M10 Conical Nuts (4pcs) and detach the
tyre.(Attached Figure 4-2-20)
4.3.2.2:Inspection of wheel components
1、Check if the wheel hub has any distortion, rust, crack or
other potential defects. If so, please replace the wheel hub.
2、。Check if the tyre has reached its maximum wear condition
in which case it should be replaced.
3、Check the joining condition of the tyre and wheel hub.
If the joint of tyre and wheel hub is loose, replace the tyre
immediately.
4、Check the vibration of tyre/wheel hub.
Vibration of assembled Tyre must be controlled within 3mm.
Otherwise, please replace with new tyre.
To Next Page
Loading...
